ADEMCO
Vista-15 Installation And Setup Manual page 65

ADEMCO Contact ID Reporting takes the following format:
CCCC Q EEE ZZZ
where:
Code Definition
110 Fire Alarm
121 Duress
122 Alarm, 24-Hour Silent
123 Alarm, 24-Hour Audible
131 Alarm, Perimeter
132 Alarm, Interior
134 Alarm, Entry/Exit
135 Alarm, Day/Night
143 Alarm, Expansion Module
146 Silent Burglary
150 Alarm, 24-Hour Auxiliary, 24-Hour Monitor
301 AC Power
302 Low System Battery/Battery Test Fail
305 System Reset
321 Bell/Siren # 1 Trouble
333 Trouble or Tamper Expansion Module
344 RF Receiver Jam Detection
351 Telco Line Fault
353 Long Range Radio Trouble
373 Fire Loop Trouble
CCCC = Customer (subscriber) ID
Q = Event qualifier, where: E = new event, R = restore
EEE = Event code (3 hexadecimal digits)
NOTE: For a complete list of event codes, refer to the Central Station office
receiver manual.
ZZZ = Zone/Contact ID number reporting the alarm, or user number for open/close
reports. System status messages (AC Loss, Walk Test, etc.) contain zeroes in the
ZZZ location.
TABLE OF CONTACT ID EVENT CODES
Section 11: System Communications
Code Definition
374 Exit Error Alarm
380 Global Trouble, Trouble Day/Night, Hard-wired
Short, Single expired Cross Zone fault.
381 RF Supervision Trouble
383 RF Sensor Tamper
384 RF Sensor Low Battery
401 Arm/Disarm for AWAY or MAXIMUM
406 Cancel by User
407 Remote Arm/Disarm (Downloading)
408 Quick Arm AWAY/Max
441 Arm/Disarm for STAY/INSTANT/NIGHT-STAY
570 Bypass
602 Periodic Test
606 AAV to Follow
607 System Test
623 Event Log 80% Full
629 1-1/3 Day No Event
11–3