ADEMCO
Vista-15 Installation And Setup Manual page 45

10 INPUT S/N
A 0 2 2 - 4 0 6 4
To Delete a Serial
XMIT TO CONFIRM
PRESS
Numbers do not match
after activating the
Zn ZT RC In:
10 03
PROGRAM ALPHA?
0 = NO 1 = YES
E N T E R Z N N U M .
( 0 0 = Q U I T )
NOTE: Following the successful enrollment of each wireless device, remove ONE of the serial number labels from the
device and affix it in the appropriate column on the ENROLLED TRANSMITTERS worksheet of the Programming
Form; then enter the other information (zone number, zone type, loop number, etc.) relevant to that device. This
information would be useful if any troubleshooting is needed later on. The installer may want to consider leaving this
worksheet at the site (in the panel cabinet).
If serial/loop number combination is not a duplicate in the system, a
L
display showing the serial number and loop number entry appears.
1
Press [
To delete an existing serial number, enter 0 in the loop number field.
Number → The serial number changes to 0's.
10 INPUT S/N:
A 0 0 0 - 0 0 0 0
If 0 was entered in error, simply re-enter the loop number, and the
serial number returns to the display.
Press [
Confirmation Option: This prompt only appears if you answered Yes at
the first prompt in this section on page 16-1.
✱
TO SKIP
The system enters a confirmation mode so that the operation of the actual
programmed input can be confirmed. Activate the loop input or button
that corresponds to this zone.
We recommend that you confirm the programming of every
transmitter before proceeding to the next zone.
If Serial or Loop If the serial/loop number combination transmitted does not match the
serial number entered, a display similar to the one below appears. If the
loop number does not match, it is also displayed.
transmitter
➜
If so, activate the transmitter's loop input or button one or more times.
If a match is still not obtained (i.e., summary display does not appear),
press the [#] key twice and enter the correct loop input or, if correct,
press the [#] key again and then enter the correct serial number.
If the serial number transmitted matches the serial number entered, the
L
keypad beeps 3 times and a summary display appears, showing that
10 RF: 1s
zone's programming. Note that an "s" indicates that a transmitter's
serial number has been enrolled.
Press [
ALPHA? prompt.
If you want to program descriptors for zones now, enter 1 (Yes) and refer to
Section 19: Alpha Descriptor Programming for available descriptors.
0
If you entered 0 (No) above, the system returns you to the ENTER ZN
NUM. prompt for the next zone.
1 1
When all zones have been programmed, enter 00 to quit.
When you have finished programming all zones, test each zone using the system's
TEST mode. Do not use the Transmitter ID Sniffer Mode for checking wireless
transmitting devices, as it only checks for transmission of one zone on a particular
transmitter, not the zones assigned to each additional loop.
✱
] to continue.
L
0
✱
] to accept.
K e y d A 0 2 2 - 4 0 6 3
R c v d A 0 2 2 - 4 0 6 4
✱
] to accept the zone information and display the PROGRAM
Section 6: Zone Programming
1
1
6–3