ADEMCO
Vista-15 Installation And Setup Manual page 58

VISTA-15/VISTA-15CN Installation and Setup Guide
Summary Mode Display
È
Default Descriptor
✳ Z N 0 1 Z O N E 0 1
Flashing Cursor (system
is ready for entry of
word).
✳ Z N 0 1
Flashing Cursor
✳ Z N 0 1 B A C K
✳ Z N 0 1 B A C K
Ç
Flashing Cursor if "6" is
pressed (system is ready
for next word) .
✳ Z N 0 1 B A C K
D O O R
Ç
Flashing Cursor
✳ Z N 0 1 B A C K
D O O R
F l a s h i n g Cursor if "6"
is pressed (system is
ready for next word) .
Summary Display
✳ Z N 0 1
D O O R
9–2
If you did not enter a descriptor previously for zone 1, the keypad
displays the default descriptor for zone 1.
Note that this is a "summary mode," and that no entries can be made.
Entries can be made only when the display contains a flashing cursor,
which signifies the "entry mode."
È
5. To delete or change the default descriptor for zone 1, press
same zone number (01). This clears that descriptor and allows changes
to be made at the flashing cursor.
NOTE: If you do not wish to change the existing descriptor for zone 1,
✱
enter
a descriptor. A summary display for that zone appears. You must then
✱
press [
mode (flashing cursor) for that zone.
È
Press [#] plus the 3-digit number for the first word from the Alpha
6.
Vocabulary List.
EXAMPLE: The descriptor that we wish to enter for zone 1 is BACK
DOOR. From the list, BACK = 013. Therefore, we enter
[#] 0 1 3 .
NOTE: If you accidentally enter the wrong word, simply press [#] plus
the correct 3-digit number for the word you want.
7. Press 6 to accept the selected word and continue.
NOTE: If this is the only word you are using for the descriptor, press 8
instead of 6 to save that word in memory, and then go to step 11.
8. Enter the 3-digit number for the next word. In our example, the word is
DOOR, whose number is 057.
Enter [#] 0 5 7. The display at left appears.
9. Press 6 to accept the selected word.
NOTE: If these are the only words/numbers you are using for the
descriptor, press 8 instead of 6 to save them in memory.
Ç
10. The two words/numbers in our example have now been entered. Note,
however, that up to three words/numbers may be entered (provided the
number of characters fit on the screen). Press 8 to save all words in
memory.
The flashing cursor disappears, indicating that the word(s) are stored in
B A C K
memory for that zone, as shown in the summary display at the left.
11. To enter a descriptor for the next zone, press
number (for example
appears. Now repeat Steps 6 through 10 for the descriptor for the next
zone.
12. To exit the alpha descriptor mode, press 00 at the summary display.
plus the next zone number for which you wish to enter (or check)
] plus the same zone number again to gain access to the entry
✱
02 ). The summary display that followed step 4
✱
plus the
✱
plus the desired zone