ADEMCO
Vista-15 Installation And Setup Manual page 49

ENTER START
ZONE 00 = QUIT 22
↑
Example of zone
suggested by the
system. This indicates
that zones 22, 23, 24,
and 25 are available.
INPUT S/N L
AXXX-XXXX –
XMIT TO CONFIRM
✱
PRESS TO SKIP
K e y d A 0 2 2 - 4 0 6 3 –
R c v d A 0 2 2 - 4 0 6 4 3
NOTE: Following the successful enrollment of each wireless device, remove ONE of the serial number
labels from the device and affix it in the appropriate column on the ENROLLED TRANSMITTERS
worksheet of the Programming Form; then enter the other information (zone number, zone type, loop
number, etc.) relevant to that device. This information would be useful if any troubleshooting is needed
later on. The installer may want to consider leaving this worksheet at the site (in the panel cabinet).
6. The system searchs for the highest zone number available, subtracts
the number of consecutive zones required for the device (four zones in
the case of the 5804 and 5804BD), and displays the lowest zone number
of the group.
If you want to start at a different zone, enter the zone desired and press
✱
[ ].
If that zone number is displayed, the system has the required number
of consecutive zones available, beginning with the zone you entered. If
not, the system again displays a suggested zone that can be used.
If the required number of consecutive zones is not available at all, the
system displays "00".
✱
7. Press [ ] to accept.
8. Enter the serial number of the wireless key or depress any button to
transmit from the wireless key.
✱
9. Press [ ] to accept the serial number. The system checks for a
duplicate number.
10. If necessary, press the [#] key to back up without saving, and re-enter
the serial number.
If you are manually entering the serial number, use the [A] key to move
forward within the screen, and the [B] key to move backward.
11. If you entered "Yes" at the SET TO CONFIRM? prompt previously
(see first prompt following entry into the
Mode on page 16-4), the display on the left appears. Confirm serial and
loop numbers by activating the wireless key.
If the serial number transmitted does not match the serial number
entered, a display similar to the one at left appears.
If it doesn't match, press any button on the transmitter once again. If
a match is not obtained, press the [#] key and then enter the correct
serial number (steps 8 through 10 above).
If the serial number transmitted matches the serial number
entered, the keypad beeps 3 times and returns you to step 6 above to
enter the starting zone for the next wireless key.
Section 6: Zone Programming
✱
58 Expert Programming
6–7