Ipv6 Firewall Setup - Draytek Vigor2130 Series User Manual

3 . 8 . 3 I P v 6 F i r e w a
3 . 8 . 3 I P v 6 F i r e w a
This page allows users to set firewall for the protocol of IPv6.
Note: Section 4.4 Firewall is configured for IPv4 packets only.
Name
Protocol
Source IP
Destination IP
Source Port
Destination Port
Action
RADVD - The router advertisement daemon (radvd) sends
Router Advertisement messages, specified by RFC 2461,
to a local Ethernet LAN periodically and when requested
by a node sending a Router Solicitation message. These
messages are required for IPv6 stateless autoconfiguration.
Advertisement Lifetime - The lifetime associated with
the default router in units of seconds. It's used to control
the lifetime of the prefix. The maximum value corresponds
to 18.2 hours. A lifetime of 0 indicates that the router is not
a default router and should not appear on the default router
list.
l l S e t u p
l l S e t u p
Display the name of the rule.
Display the protocol (TCP/UDP/ICMPv6) the rule uses.
Display the source IP address of such rule.
Display the destination IP address of such rule.
Display the source port number of such rule.
Display the destination port number of such rule.
Display the status (accept or drop) of such rule.
88
Vigor2130 Series User's Guide