Panasonic UF-890 Service Manual page 309

9.6.3.3 Error Message appears on the PC
Problem
Error in writing to LPT1.
Unable to write to the Specified
device.
Error in writing to LPT1.
Printer timeout error occurred.
Printing is disabled due to an error in
the current printer settings.
Cannot print because an error is
found in the current printer setting.
9.6.3.4 Error Message appears on the Panafax facsimile unit
Error Message
* PRINTING PC DATA *
Insufficient Memory
* PRINTER MODE *
WRONG PAPER SIZE
Verify that the device is connected to the computer correctly.
Verify that the power of the device is turned on.
Verify that the paper is properly loaded.
Verify that the power of the device is turned on.
Excessive data volume or number of pages may overflow the device's memory,
disabling data reception.
Increase the timeout setting value in properties (for transmission retry).
• Refer to the Software Operating Instructions of Panasonic Printing System Ver. 6
Windows 95/98/Me
Windows NT 4.0
Windows 2000/XP
Differences in settings such as paper size or printing orientation exists between the
application and the printer driver.
Specify the correct settings.
Verify and specify the paper size or orientation to coincide with the application
and the printer driver settings.
• The available page memory on the Panafax facsimile unit may not be
enough. Either install an Expansion D-RAM Card or change the
resolution to 300 dpi in the Printer Driver Properties dialog box.
• The Paper Size setting on the Panafax facsimile unit may be set
incorrectly (i.e. Installed A4 size paper but the setting is for Letter size
and specify to print a A4 size document). Check if the paper size is
properly set.
• Check if the Page Size setting specified in the document is coincide with
the setting in the Printer Driver Properties dialog box.
Action
[Details Tab] (See page 22)
[Ports Tab] (See page 34)
[Ports Tab] (See page 49)
Solutions
309