Panasonic UF-890 Service Manual page 180

Note 1: No. 070 LINE ERROR-Transmit condition of RTP/PIP or RTN/PIN
Signal
MCF/PIP
RTP/PIP
RTN/PIN
Note 2: No. 071 TOTAL ERROR-Transmit condition of RTP/PIP or RTN/PIN
Note 3:
The default setting of parameters depends on the destination's specifications or regulations.
Print the Function Parameter List to confirm the default settings.
Note 4:
Continuous Polling (Station Mode)
This feature allows you to store or add documents into a polled file in memory.
To enable the Continuous Polling feature set Function Parameter No. 003 to "2:Station". The Program
Key [P8] will be assigned with the "Store-4-Polling" name automatically and cannot be changed.
To prepare the document(s) to be polled, simply place the document(s) on the ADF and then press the
Program Key [P8] to store or add the document(s) into a polled file.
(Note: If a regular polled file ([FUNCTION][3][2]) is stored in memory, the Program Key [P8] for
Continuous Polling will not be accepted.)
Continuous Polling (Hub Mode)
When the polling command is initiated, the machine will continuously poll documents from the remote
stations until it is interrupted by pressing "STOP".
Note 5:
200 Series Function Parameters Only appear when the G3 Communications Port Kit is installed and
follow the same numbering order.
1:128 2:256
0-31 0-63
32-63 64-127
64-127 128-255
Signal
1:5%
MCF/PIP 0-2
RTP/PIP 3-4
RTN/PIN 5-
Setting
3:512 4:1024
0-127 0-255
128-255 256-511
256-511 512-1023
Setting
2:10% 3:15%
0-4 0-7
5-9 8-14
10- 15-
180
5:2048 6:Off
0-511 Always
512-1023 -
1024-2047 -
4:20%
0-9
10-19
20-