Panasonic UF-890 Service Manual page 210

5.1.9 Service Mode 9 (System Maintenance)
5.1.9.1 Overview
This Service Mode is used to maintain and/or update the firmware of the machine.
Use the following procedure for System Maintenance.
Step
1 Standby
2 Press "FUNCTION" and then "7".
3 Press "MONITOR" four times, then press "*".
4 Press "9".
5 Press "START" to update the firmware.
Enter No. or press "/\" or "\/" to select the maintenance
to be performed.
Ex: Enter "2".
6 Press "START" and "SET".
7 After the backup is completed, repeat step 5 through 6
to request an operation.
8 Press "STOP" to return to standby.
No. Maintenance Mode
1 FIRMWARE UPDATE
2 FIRMWARE BACKUP Creates a Backup Card of the machine's firmware.
3 PARAMETER
RESTORE
4 PARAMETER BACKUP Creates a Backup Card of the machine's parameters.
PC → FLASH CARD
5
8 SEND RECEIVED FILE Transfers documents from memory to another fax machine
Operation or Unit Condition
System Maintenance Table
Updates the firmware in the machine with the Master Firm-
ware Card.
(A 2 MB or higher Flash Memory Card is required)
Restores the parameters from the Backup Card into the
machine.
(A 1 MB or higher Flash Memory Card is required)
Creates a Master Firmware Card using the Firmware
Update Tool.
(A 2 MB or higher Flash Memory Card is required)
during a fatal printer error.
Description
210
LCD Display
FEB-12-2002 15:00
00%
SET MODE (1-6)
ENTER NO. OR
SERVICE MODE
ENTER NO. OR
SYSTEM MAINT. (1-8)
1:FIRMWARE UPDATE
SYSTEM MAINT. (1-8)
2:FIRMWARE BACKUP
FIRMWARE BACKUP
* IN PROGRESS *
SERVICE MODE
ENTER NO. OR
FEB-12-2002 15:00
00%