Panasonic UF-890 Service Manual page 203

5.1.7 Service Mode 7 (LBP Service Mode)
This test mode is used to change printer parameters and verify printer information.
Use the following procedure to change printer parameters.
Step
1 Standby
2 Press "FUNCTION" and then "7".
3 Press "MONITOR" four times, then press "*".
4 Press "7".
5 Press "START" for printer parameter settings.
Press "2" and "START" to get the printer information.
Ex: Enter "START" for printer parameter settings.
6 Press "3" and "START". Then enter the number of
pages.
Ex: Enter "50" and "START".
7 Repeat step 5 through 6 to request operation, or press
"STOP" to return to standby.
Sub-Code
1
\//\
\//\
2
\//\
Operation or Unit Condition
Parameter Name
1 Printer Counter
2 LBP Fuser Reset
3 Out of Toner
LBP ROM Version
LBP Print Available Shows the remaining number of allowable print-
LBP MEMORY
CAPACITY
Description
Displays and resets the printer and cassette(s)
counters.
Clears the LBP fuser error.
Sets the number of pages to print after low toner
is detected. (Factory default = 100, adjustable
from 0 - 999)
Shows the LBP ROM Version.
able pages after low toner has been detected
(Counter Only).
Shows the page memory capacity.
203
LCD Display
FEB-12-2002 15:00
00%
SET MODE (1-6)
ENTER NO. OR
SERVICE MODE
ENTER NO. OR
LP SERVICE MODE (1-2)
1:LBP PARAMETER SET
LBP PARAMETER SET
1.PRINTER COUNTER
LBP PARAMETER SET
3.OUT OF TONER
FEB-12-2002 15:00
00%