Panasonic UF-890 Service Manual page 174

Parameter
No.
(see Note 3)
013 G3 RX EQL
014 G3 TX EQL
015 Not Used
~
016
017 TX START
018 RX START
019 ITU-T V.34
020 ITU-T ECM
021 EP TONE
022 SIGNAL INTERVAL
023 TCF CHECK
024 CED FREQUENCY
Function Parameter Table
Selections
1 = 0dB
2 = 4dB
3 = 8dB
4 = 12dB
1 = 0dB
2 = 4dB
3 = 8dB
4 = 12dB
1 = 2400 bps
2 = 4800 bps
3 = 7200 bps
4 = 9600 bps
5 = TC7200 bps
6 = TC9600 bps
7 = 12000 bps
8 = 14400 bps
1 = 2400 bps
2 = 4800 bps
3 = 7200 bps
4 = 9600 bps
5 = TC7200 bps
6 = TC9600 bps
7 = 12000 bps
8 = 14400 bps
1 = Off
2 = On
3 = Select
1 = Off (Invalid)
2 = On (Valid)
1 = Off (without EP Tone)
2 = On (with EP Tone)
1 = 100 ms
2 = 200 ms
3 = 500 ms
1 = Normal (Short)
2 = Long
1 = 1080 Hz (non CCITT)
2 = 2100 Hz
174
Function
Selects the cable equalizer for G3
reception mode, 0dB, 4dB, 8dB or 12dB.
Selects the cable equalizer for G3 trans-
mission mode, 0dB, 4dB, 8dB or 12dB.
Selects the transmission modem start
speed, 14400/12000/TC9600/TC7200/
9600/7200/4800/2400 bps.
Note:
This parameter is applicable only
when communicating with regular G3
machines. When communicating with
Super G3 (V.34) machines, use
Parameter No. 32.
Selects the reception modem start
speed, 14400/12000/TC9600/TC7200/
9600/7200/4800/2400 bps.
Note:
This parameter is applicable only
when communicating with regular G3
machines. When communicating with
Super G3 (V.34) machines, use
Parameter No. 33.
Selects whether the ITU-T V.34 is Off,
On or Select.
(Select: Select whether the ITU-T V.34
is Off or On, when entering One-Touch/
Abbreviated Dialing Numbers or Manual
Number Dialing.)
Select the ECM mode.
Selects the echo protect tone on V.29
mode, On (add) or Off (Not add).
(Used when Echo Suppression is
disabled.)
Selects the time interval between the
receiving signal and the transmitting sig-
nal.
Selects the TCF check interval Long/
Short
Selects the CED frequency 2100/1080
Hz