Panasonic UF-890 Service Manual page 160

Code Mode Phase
407 XMT
408 XMT
409 XMT
410 RCV
411 RCV
(Polling)
412 G3 RX
414 RCV
(Polling)
415 XMT
(Polling)
416 RCV
417 RCV
Information Codes
Description of Problem
D Transmitter received no response
after it transmitted post message,
such as EOP, MPS, EOM, etc...or
received DCN.
D Transmitter received RTN after it
transmitted EOP, MPS, or EOM.
D Transmitter receives PIN after it
transmitted a post message, such
as EOP, MPS, EOM, etc.
D Received DCN while waiting for
post command. (EOP, MPS, EOM,
etc.)
B Received DCN after transmitting
NSC.
B, D No response within 12 seconds in
NSS/DCS/MPS wait state.
(After transmitting FTT)
B No response received after
transmitting 3rd NSC.
B Remote side attempted to receive
message from your machine in
polling communication.
Inform the remote side that your
machine does not have the polling
transmission feature.
D Receiver did not detect post
command, such as EOP, MPS,
EOM, etc.
C Receiver returned RTN in
response to post message.
Receiver is defective.
(No paper, paper jamming, etc.)
Receiver ceased receiving
because of
excessive error.
(Line quality is poor)
FCB PCB (Modem) or LCU PCB is
defective.
Receiver receives data with error.
(Line quality is poor)
Receiver is defective.
(Modem, LCU, etc.)
FCB PCB or LCU PCB are
defective.
Receiver receives data with error
due to poor line quality, and
receiving operator requests voice
contact.
Receiver is defective.
(Modem, LCU, etc.)
FCB PCB or LCU PCB are
defective.
Interface or line is faulty.
Transmitter is
defective.
Transmitter is not ready for polling
communication.
Password does not match
between transmitter and receiver.
Transmitter is defective.
FCB PCB is defective.
Password does not match
between transmitter and receiver.
Transmitter is defective. (No
document, document jam, etc.)
Transmitter is defective.Line
quality is poor. (RTC signal is
distorted due to line noise)
FCB PCB or LCU PCB are
defective.
Line quality is poor. (There are
excessive errors in received data)
FCB PCB or LCU PCB are
defective.
160
Cause