Panasonic UF-890 Service Manual page 158

Code Mode Phase
051 RCV
COPY
054 STANDBY
RX
COPY
055 STANDBY
RX
COPY
058 -
059 RCV
COPY
060 -
061 -
063 -
064 -
212 XMT
RCV
301 XMT
RCV
302 XMT
RCV
331 XMT
340 -
360 -
Information Codes
Description of Problem
- Printer Motor is abnormal.
- HSYNC is abnormal.
Laser motor is abnormal.
- No response of LBP CPU on LPC. Defective LPC PCB.
A Interface error occurred with the
500-sheet optional cassette feeder.
C Interface error occurred between
FCB PCB and LPC PCB.
A Printer Cover is open.
A ADF Door is open.
A Jam Access Cover is open.
A Jam Access Cover is open.
A-E Interface error occurred between
the CPU and modem.
- System fault.
- No response of 2nd G3 PCB.
C 8-minutes timer error.
(Germany only)
- Interface failure between the G3B
PC Board and the FCB PC Board.
- Incomplete initialization for EP
PCB.
Connector not properly
connected.
Defective Printer Motor.
Defective LPC PCB.
Defective Laser Unit.
Defective FCB PCB.
Defective CST3 PCB.
Defective LPC PCB.
Defective FCB PCB.
Cover is not firmly closed.
Connectors are not firmly
connected.
Cover is not firmly closed.
Connectors are not firmly
connected.
Cover on the optional 2nd
cassette is not closed.
Cover on the optional 3rd cassette
is not closed.
Modem is defective. (FCB PCB)
Software problem occurred.
(FCB PCB)
Software problem occurred.
(FCB PCB)
2nd G3 PCB defective.
FRM PC Board incorrectly
installed on the G3B PC Board.
Defective FRM PC Board.
Defective G3B PC Board.
Defective FCB PC Board.
(UF-990 Only)
EP PC Board incorrectly installed
on the FCB PC Board.
FRM PC Board incorrectly
installed on the EP PC Board.
Defective EP PC Board.
Defective FRM PC Board.
Defective FCB PC Board.
158
Cause