Panasonic UF-890 Service Manual page 178

Parameter
No.
(see Note 3)
082 JAM LENGTH
083 Not used
084 LINE AS NO PAPER
085 Not used
086 REDUCTION FINE
087 DARKER LEVEL
088 NORMAL LEVEL
089 LIGHTER LEVEL
090 PRINT DENSITY
091 Not used
092 SMOOTHING
093 Not used
~
129
130 BUSY-ACK TIMING
131 CMD RCV GRD
TIMER
132 PRT DATA TIMER
133 COLLATION (PRT)
135 JOB END TIMER
Function Parameter Table
Selections
1 = 1 m
2 = 2 m
3 = 8 m
4 = Unlimited
1 = Ring (ring)
2 = Busy (keep line busy)
1 = Off
2 = On
0 = Lightest Contrast
~
15 = Darkest Contrast
1 = Normal
2 = Darker
1 = Off
2 = On
• In Busy
• While Busy
• After Busy
1 min.
~
15 min.
1 min.
~
15 min.
1 = Off
2 = On
3 = Auto
1 sec.
~
999 sec.
178
Function
Selects the maximum length of the
document that can be scanned.
Selects whether to ring or send a busy
tone to the remote station when the
recording paper runs out or the unit
cannot receive because of any trouble.
Selects whether the resolution is preset
to Fine, when sending with reduction
B4→A4.
Selects the contrast level.
→15
0←
Lightest← →Darkest
Selects whether or not the Printed page
is Darker. (except PC printing)
Selects whether the smoothing function
is available.
Selects the signal timing between the
BUSY and ACK signal in Printer
Interface Mode.
Selects the Guard Timer between each
GDI Command in Printer Interface
Mode.
Selects the Guard Timer between each
GDI Data Frame in Printer Interface
Mode.
Selects the Print Collation in Printer
Interface Mode.
When "Auto" is selected, print collation
will operate according to the setting in
Fax Parameter #65.
Selects the Guard Timer while printing
data with the Panafax Printing System
ver. 6.