Panasonic Foma p705im Instruction Manual page 99

Information
≥ When you select "YES" from the confirmation display asking whether to connect
to the site, the line is connected to the i-mode site. You are not charged a packet
communication fee for connecting to the site for settings, however, you are
charged for connecting to the IP site, i-mode menu site, and free melody corner.
< >
Keypad Sound
Setting Keypad Sound
m1Settings1Sound1Keypad sound1ON or OFF
1
Information
≥ The sound volume for keypad sound cannot be changed.
≥ If you set this function to "OFF", the battery level tone (see page 43) and
respective warning tones do not sound.
≥ The keypad does not make a sound when you press
playback of a moving image or i-motion movie.
. > with your FOMA phone closed, the FOMA phone works
≥ When you press
according to "Info notice setting" on page 111.
< Charge Sound >
Setting Charging-start/end Tones
The confirmation tone sounds twice when charging starts/ends.
1 m1Settings1Other settings1Battery
1Charge sound1ON or OFF
Information
≥ The sound volume for charge sound cannot be changed.
≥ The charging confirmation tone does not sound when a display other than the
Stand-by display is shown or during Manner Mode or Public Mode (Drive Mode).
< Quality Alarm
Sounding Alarm when a Line is Likely to
be Disconnected
When a call is likely to be disconnected midway due to bad radio wave
conditions, an alarm sounds to inform you right before disconnection.
+ m - 3 0 -
1
Information
≥ You might be disconnected without hearing an alarm if radio wave conditions
deteriorate suddenly.
≥ An alarm for "Quality alarm" sounds only from the earpiece during a videophone
call.
. < , during ringing, or during
< Mail/Message Ring Time
Setting Ring Time for Mail and Messages R/F
You can set the duration of the ring tone which sounds for incoming
i-mode mail, SMS messages, Chat mail and Messages R/F.
1
>
m1Settings1Talk1Quality alarm1Select an alarm.
No tone . . . . . Does not sound.
High tone . . . High alarm sounds.
Low tone . . . . Low alarm sounds.
>
m1Settings1Sound1Mail/Msg. ring time
1Select a type of mail or message1ON or OFF
1Enter a ring time (seconds).
≥ Enter in two digits from "01" through "30".
m + 7 - 5 -
m + 6 - 8 -
97