Executing Initial Settings; Setting Date And Time - Panasonic Foma p705im Instruction Manual

< >
Initial Setting

Executing Initial Settings

If the date and time, Terminal Security Code, Keypad Sound, or
Character Size is not set, the Initial Setting display appears when the
power is turned on. You can set the initial settings also from each
menu function separately.
1
Turn on the power1YES
≥ When the display for entering your Terminal Security
Code, PIN 1 code, or PIN 2 code appears, follow the
operation on page 44.
2
Set the date and time.
You can select "Auto time adjust ON" or "Auto time adjust OFF" for setting the
time. (See page 45)
3
Set your Terminal Security Code.
You can set your Terminal Security Code required for setting functions.
(See page 120)
1. Enter "0000"1Enter your new Terminal Security Code (four to eight digits)
1YES
4
Set Keypad Sound.
You can set the keypad whether to make a sound. (See page 97)
1. ON or OFF
5
Set the size of characters.
You can set the size of characters on the display at a time. (See page 115)
Information
≥ When an unset function is found, the Initial Setting display for an unset function
appears each time you turn on the power.
≥ The completed settings are valid even when total setting is interrupted by an
incoming call or canceled by pressing
h or - r midway. -
Information
≥ When the power is automatically turned on by alarm notification, the Initial Setting
display does not appear even if there is any unset function.
≥ When you finish the initial settings, the confirmation display appears telling that
updating software is executed automatically. This display appears only at the first
time, and after that, does not appear until you execute Reset Settings or Initialize.
< >
Set Time

Setting Date and Time

You can select whether to correct the time automatically or set it
manually. The time is set/displayed on the 24-hour basis.
m1Settings1Clock1Set time
1
1Auto time adjust ON or Auto time adjust OFF
Auto time adjust ON
. . . .Corrects the date/time automatically. The setting is completed.
If the time is not automatically corrected such as when "
and the date/time has not been set, the display for manually correcting the
time appears. Follow step 2 to set the date/time.
Auto time adjust OFF
. . . .Sets the date/time manually.
≥ When "Notice call cost" is set to "ON", you need to enter your Terminal
Security Code.
2
Enter year, month, date and time.
o to move the cursor and enter numbers by the M
Use
numeric keys.
≥ To enter one-digit numeral for the date and time,
enter two digits beginning with "0" as in "01" through
"09".
≥ Highlight "time zone" and press l(
o ( O
select a region and press
m + 3 - 1 -
" is displayed
o to M
) to set the time zone. Use
).
45