Panasonic Foma p705im Instruction Manual page 525

8
Click "
(recommended)]".
Then install the FOMA byte counter.
Install by following the onscreen instructions.
≥When you do not install the FOMA byte counter, go to step 9.
9
Click " (Complete)".
Next, confirm that the "FOMA communication setup files" (driver) are
installed correctly. (See page 32)
Confirm Installed Driver
Confirm that the "FOMA communication setup files"
(driver) are installed correctly.
1
" [ (Start)]"1Open "
(Control panel)"1"
(System and maintenance)"
2
Open "
hardwares and devices)"
1Click "
(Continue)".
3
Click each device, then confirm the installed
driver names.
Confirm that all driver names are displayed under "
LPT) [Port (COM/LPT)]", "
(Universal serial bus controller)".
The COM port number varies depending on the personal computer you
use.
[Installing
(Show
(COM
(Modem)", and "
The following drivers are installed by installation of the
"FOMA communication setup files" (driver):
Device name
(COM LPT) [Port (COM/
LPT)]
(Modem)
(Universal serial bus
controller)
To set an access point with the "FOMA PC setup software", see page 34.
To set an access point without the "FOMA PC setup software", see
page 42 or page 45.
Uninstall FOMA Communication Setup
Files (Driver)
When uninstalling the "FOMA communication setup
files" (driver) is necessary (such as when upgrading the
version), perform the operation below.
≥Operate as the user who has the PC administrator right.
1
If the FOMA phone is connected to a personal
computer via the FOMA USB Cable with
Charge Function 01 (option), disconnect the
FOMA USB Cable with Charge Function 01.
2
" [
(Control panel)"1Open "
(Uninstall programs)".
3
Select "FOMA P705i
P705iCL USB" and click "
(Uninstall and change)"
1Click "
(Continue)".
4
Click "OK".
5
Click " (Yes)" to restart Windows.
The uninstallation is then completed.
≥If you click "
Information
≥ If you remove the FOMA USB Cable with Charge Function 01 from the
personal computer while installing the "FOMA communication setup
files" (driver) or click the "
installation, the "FOMA communication setup files" (driver) may not be
installed correctly. In this case, open "USB_Driver"
or "PROSOLID Drivers"
PROSOLID CD-ROM", and execute "p705iuun.exe" or
"p705clun.exe" to delete the "FOMA communication setup files"
(driver), and then install the files again.
32
FOMA communication setup file
(driver) name
FOMA P705i Command Port or
FOMA P705iCL Command Port
FOMA P705i OBEX Port or FOMA
P705iCL OBEX Port
FOMA P705i or FOMA P705iCL
FOMA P705i or FOMA P705iCL
(Start)]"1"
USB" or "FOMA
(No)", restart it manually.
(Cancel)" button to stop
"P705i Drivers"
"WinVista32" inside "FOMA P705i /