Turning Power On/Off; Switching To English - Panasonic Foma p705im Instruction Manual

< >
Power ON/OFF

Turning Power On/Off

Turn Power On
Press and hold h for at least one
1
second.
After the Wake-up display (see page 102) is displayed,
the Stand-by display appears.
≥ If you have stored many Phonebook entries or mail
messages, it may take a while for the display to
appear.
≥ If Set Time is set, the current date and time are
shown.
≥ When "
" is displayed, the FOMA phone is out of
the service area or in the place where the radio
waves do not reach. Move to a location where "
disappears.
≥ If "starting system wait a minute" is displayed when
you turn on the power, wait for a while and then
proceed.
When your UIM is replaced (except during Omakase Lock)
Enter the four- to eight-digit Terminal Security Code after turning on the power.
When you enter the correct Terminal Security Code, the Stand-by display appears. If
you enter the incorrect Terminal Security Code five times in succession, the power
turns off. (However, you can turn on the power again.)
When "PIN1 code entry set" of "UIM setting" is set to "ON"
Enter the four- to eight-digit PIN1 code after you turn on the power. When you enter
the correct PIN1 code, the Stand-by display appears. See page 121 for PIN1 code.
When "Auto reset setting" of "Notice call cost" is set to
"ON" (except during Omakase Lock)
Enter the four- to eight-digit PIN2 code after you turn on the power. When you enter
the correct PIN2 code, the Stand-by display appears. If you press r or h
without entering the correct PIN2 code, "Auto reset setting" is set to "OFF" and the
Stand-by display appears. See page 121 for PIN2 code.
44
Information
≥ Each entry display appears in the order of "PIN1 code"
Code"
Turn Power Off
1 Press and hold h for at least two seconds.
The exit display appears and the power turns off.
≥ You cannot turn on the power immediately after turning off the power. Wait a
<
Select Language

Switching to English

1
m1
1
"
1Japanese (
Stand-by display
≥ The following functions are different between Japanese display and English display:
Information
≥ When you insert the UIM, the "
the UIM.
"PIN2 code".
few seconds.
>
(Settings)1
(Select language)
) or English (
Functions
Info Notice Setting
"Clock" of Display Setting
"Day of week"
(Guide)
Voice Guidance
"Terminal Security
+ m - 1 5 -
(Display)
)
Japanese English
ON
(Electrical tone)
Not available
(Voice)
OFF OFF
Available Not available
Available Not available
Available Not available
(Select language)" setting is stored on