Table of Contents
Advertisement
8. Move the ShuttlePoint knob to highlight NAME and press [ENT] or move the Shuttle-
Point knob to the right. A popup window will be shown.
9. Move the ShuttlePoint knob up/down to change the characters and left/right to select
a different character in the Routes Name.
10. When finished press [ENT] to save.
11. Press [CLR] to show the Chart page is shown.
9.5
INSERTING A WAYPOINT INTO A ROUTE
On the CPF180i place the cursor on the navigation line between two Waypoints and press
[ROUTE]. On the CPF300i placing the cursor on the navigation leg between two points, Soft
Key labels appear: press [I
dotted line, see the following picture.
Move the ShuttlePoint knob to the desired location for the new Waypoint: the line will
"rubber-band", drawing a dotted line between the previous Waypoint and the cursor, and
another dotted line between the cursor and the next Waypoint (see the left side of the above
picture). Once you have positioned the cursor at the location you want, press [ENT] (see
the right side of the above picture).
9.6
GOTO A ROUTE
By having created some Routes, you can choose one of them to place a GOTO on.
9.6.0
Using [GOTO] to select Route
1. Move the ShuttlePoint knob to an open position (no buoy, warning etc. under the cursor)
on the Chart page.
2. Press [GOTO] to show the GOTO popup window.
CPF180i and CPF300i
]. The line between the two Waypoints is turned into a
NSERT
Figure 9.5 - Inserting Waypoint procedure (1)
Figure 9.5a - Inserting Waypoint procedure (2)
Page 69
Advertisement
Table of Contents
