Inserting A Waypoint Into A Route - Standard Horizon CPF180i Owner's Manual

2. Next move the ShuttlePoint knob until the cursor is over the Mark that you want to be
the next leg in the Route.
3. Press [ROUTE]. You will notice a bearing line joins the first and second Mark which
means these Marks are selected into the Route.
4. Repeat steps 3 and 4 until all Marks are entered into the Route.
At this point the Route is saved as ROUTE01. If you would like to save the Route under a specific
name follow the remaining steps.
5. To name the Route press [MENU]. Move the ShuttlePoint knob to highlight USER
POINTS and press [ENT].
6. Move the ShuttlePoint knob to highlight ROUTE and press [ENT].
7. Move the ShuttlePoint to highlight EDIT ROUTE and press [ENT] or move the
ShuttlePoint knob to the right.
8. Move the ShuttlePoint knob to highlight NAME and press [ENT] or move the Shuttle-
Point knob to the right. A popup window will be shown.
9. Move the ShuttlePoint knob up/down to change the characters and left/right to select
a different character in the Routes Name.
10. When finished press [ENT] to save.
11. Press [CLR] to show the Chart page is shown.
9.5

INSERTING A WAYPOINT INTO A ROUTE

On the CPF180i place the cursor on the navigation line between two Waypoints and press
[ROUTE]. On the CPF300i placing the cursor on the navigation leg between two points, soft
key labels appear: press [I
line, see the following picture.
Move the ShuttlePoint knob to the desired location for the new Waypoint: the line will
"rubber-band", drawing a dotted line between the previous Waypoint and the cursor, and
another dotted line between the cursor and the next Waypoint (see the left side of the above
picture). Once you have positioned the cursor at the location you want, press [ENT] (see
the right side of the above picture).
Page 78
NOTE
]. The line between the two Waypoints is turned into a dotted
NSERT
Figure 9.5 - Inserting Waypoint procedure (1)
CPF180i and CPF300i