Table of Contents
Advertisement
This mode is used by dealers to promote the features of the CPF180i or CPF300i when on a retail
shelf.
The Demo Mode can be selected from the Simulation Menu following the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press
[ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight SIMULATION and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight DEMO MODE and press [ENT] or move the
ShuttlePoint knob to the right to show the popup window.
5. Move the ShuttlePoint knob to select ON and press [ENT] or move the ShuttlePoint
knob to the right.
6. Demo Mode is now activated.
Once the Demo Mode is enabled, it is possible to temporally exit Demo Mode by pressing
a key and return to the GPS Chart Plotter normal operation. If a key in not touched for 30
seconds the Demo Mode will re-start.
To disable the Demo Mode follow the procedure above selecting OFF at point 5.
Page 26
NOTE
CPF180i and CPF300i
Advertisement
Table of Contents
