Menu; Ais Setup; Quick Info On Ais Target - Standard Horizon CPF180i Owner's Manual

A Target is removed from the screen if data is not received for 10 minutes.
The maximum number of tracked Class A or B Targets is 200.
This information is updated every 3 seconds to 6 minutes depending on speed and rate of turn,
enabling the track of the vessels in range to be plotted.
14.1

MENU

To configure the GPS Chart Plotter to receive AIS data, follow the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight AIS SETUP and press [ENT] or move the
ShuttlePoint knob to the right. The new AIS menu appears on the screen. The available
functions are described in the following table.
Display : Turns the display of AIS Targets overlay on the cartography On or Off. The default setting is On.
Activation Range : Defines the range from the fix within which the AIS Target becomes active. The values allowed
are from 0.1 to 20 Nm. The default setting is 5Nm.
CPA Alarm : Turns On or Off the alarm. The default setting is On.
CPA Limit : The values allowed are from 0.1 to 10 Nm. The default setting is 0.5Nm.
TCPA Alarm : Turns On or Off the alarm. The default setting is On.
TCPA Limit : The values allowed are from 1 to 30 Min. The default setting is 10 Min.
14.2

AIS SETUP

Refer to Par. 2.4 for connections.
14.3

QUICK INFO ON AIS TARGET

By placing the cursor over a AIS Target icon using the ShuttlePoint knob, the following
information is displayed (see the following picture):
Page 102
NOTE
Figure 14.0 - AIS Symbols
Figure 14.3 - Quick Info on AIS
CPF180i and CPF300i