Table of Contents
Advertisement
2. Move the ShuttlePoint knob to highlight DATA and press [ENT].
3. Connect the Blue wire on the GPS Chart Plotter to the junction of the Brown wire and
the VHF wire. The display should look similar to the following picture.
4. Press [ENT] to freeze the data on the display so it is easy to read and understand.
5. Press [ENT] again to receive data again.
6. View data from a device connected to another data port, press the [ZOOM IN].
12.8
NMEA TREND PAGES
The CPF180i and CPF300i have the following NMEA Trend pages.
Trends will be shown for Depth, Temp and Speed (DST521 or DST526 must be connected
to show Speed Through the Water) when a STANDARD HORIZON transducer is connected.
To show Wind trend information the CPF180i or CPF300i must be connected to the NMEA
output of a external wind instrument. To select a NMEA Trend Page:
1. Press [MENU], move the ShuttlePoint knob to highlight NMEA DISPLAY and press [ENT].
CPF180i and CPF300i
Figure 12.7 - NMEA Display menu on CPF300i
Figure 12.7a - NMEA Data page
Figure 12.8 - NMEA Display menu on CPF300i
Page 93
Advertisement
Table of Contents
