Table of Contents
Advertisement
4. The menu now shows two selections, Chart and Menu which allow the Cursor Speed
to be selected as High, Medium or Low on the Chart page or within the menus.
5. With CHART or MENU selected, press [ENT] or move the ShuttlePoint knob to the right.
Move the ShuttlePoint knob to the desired setting and press [ENT] or move the
ShuttlePoint knob to the right.
6. Press [CLR] until the menu disappears or an easier method is to press the ShuttlePoint
knob to the left a few times.
7. Move the cursor on the Chart page and see if the speed is to your liking.
3.1.3
Changing the Ship Icons
The cursor may be changed to any of the following. The default setting is Icon 6.
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight SHIP ICON and press [ENT] or move the
ShuttlePoint knob to the right to show the popup window with ship icons.
4. Move the ShuttlePoint knob to select the desired icon and press [ENT] or move the
ShuttlePoint knob to the right to select a new icon.
5. Press [CLR] or move the ShuttlePoint knob to the left to exit the menu and show the
Chart page.
3.1.4
Changing the Backlight and Contrast
With the CPF180i and CPF300i turned on, briefly press [PWR] to show the backlight and
contrast popup window. Move the ShuttlePoint knob to the left or right to adjust the LCD
backlight intensity or up or down to change the LCD contrast. Press [ENT] to set.
3.1.5
Selecting North Up or Course Up
The default selection is COURSE UP: the top of the Chart page oriented so it will always
show the area ahead of the direction your vessel is travelling.
CPF180i and CPF300i
Figure 3.1.3 - Ship Icons
Figure 3.1.4 - Backlight and Contrast adjustment
Page 31
Advertisement
Table of Contents
