3. Move the ShuttlePoint knob to highlight DISPLAY MODE and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight Custom and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up or down to select the desired item within the groups
Marine Settings, Depth Settings, Land Settings, Chart Settings or Underwater Settings
and press [ENT]. See the above sections for details on selections.
12.2
NAVIGATION PAGE
The Navigation page is useful to show information when heading to a Destination, following
a compass heading or navigating to a Mark or a Route. The default page is shown with a
Compass Rose, however this can be customized to show a Compass Tape.
1. To change to show the Compass Tape, select the Chart page, press [MENU]. Move the
ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
Page 88
Figure 12.2 - Navigation page with Compass Rose
Figure 12.2a - Navigation page with Compass Tape
CPF180i and CPF300i