Table of Contents
Advertisement
2.11
CPF300i: VIDEO INPUT
By accessing this menu it is possible to see images on the CPF300i display from an external
video signal source, if connected to the CPF300i. It allows the "picture-in-picture" functio-
nality, so a Video Input image can be shown on a window or overlaid on top of the Chart,
Navigation, Highway, Celestial and NMEA pages image at full screen.
If the Video Input signals is not detected (E.g. the video camera is not connected to the Video Input
connector), the VIDEO INPUT menu item will be greyed out.
Video Connector
Pin
Description
1
Ground
2
+ 9 / 12 VDC
3
Video Signal +
2.11.0 Video Camera Input
The CPF300i has one connection for video camera. Any NTSC or PAL camera will operate
correctly. To connect use the video output of the camera and connect to the optional
ACVC10 cable.
2.11.1 VCR or DVD Input
A VCR or DVD may be connected to Video port. The CPF300i does not have speakers so
the audio from the VCR or DVD would have to be routed to a stereo system.
STANDARD HORIZON offers an optional cable called ACVC10 that allows any VCR or
DVD to simply be plugged into the CPF300i.
VCR/DVD
Video Signal GND
Video Signal OUT
The CPF300i has the capability to select the Video Input in three ways.
I. From the menu
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP and press [ENT].
2. Move the ShuttlePoint knob to highlight VIDEO INPUT and press [ENT] or move the
ShuttlePoint knob to the right. A menu appears with the following options:
a. ACTIVATE VIDEO, the possible choices are Full Screen View, PiP (Picture in
Picture) View and Auto Switch (*).
If Full Screen View is chosen, the GPS Chart Plotter will show a warning message
with the instructions to adjust the image from the Video Input. If the user agrees to
proceed, the image from the video input will be shown.
If Picture in Picture (PiP) View is chosen, a Video Input image can be shown on a
window and placed over the selected page at full screen. By moving the ShuttlePoint
knob, the PiP image is moved. When the focus is on the PiP image, press [CLR] to
Page 24
NOTE
Connection Example
Connect to Video Signal Ground of DVD/VCR/Video Cameras
Connect to Video Cameras Power Input
Connect to Video Signal + (NTSC/PAL) of DVD/VCR/Video Cameras
Audio OUT
Figure 2.11.1 - VCR/DVD Input
STEREO
SYSTEM
VIDEO CONNECTOR
1=GND
2=PWR+
3=SIGNAL
CPF180i and CPF300i
Advertisement
Table of Contents
