Inserting A Waypoint Into A Route - Standard Horizon CP190i Owner's Manual

3. Press [ROUTE]. You will notice a bearing line joins the first and second Mark which
means these Marks are selected into the Route.
4. Repeat steps 3 and 4 until all Marks are entered into the Route.
At this point the Route is saved as ROUTE01. If you would like to save the Route under a specific
name follow the remaining steps.
5. To name the Route press [MENU]. Move the ShuttlePoint knob to highlight USER
POINTS and press [ENT].
6. Move the ShuttlePoint knob to highlight ROUTE and press [ENT].
7. Move the ShuttlePoint to highlight EDIT ROUTE and press [ENT] or move the
ShuttlePoint knob to the right.
8. Move the ShuttlePoint knob to highlight NAME and press [ENT] or move the Shuttle-
Point knob to the right. A popup window will be shown.
9. Move the ShuttlePoint knob up/down to change the characters and left/right to select
a different character in the Routes Name.
10. When finished press [ENT] to save.
11. Press [CLR] to show the Chart Page is shown.
9.5

INSERTING A WAYPOINT INTO A ROUTE

Place the cursor on the navigation line between two Waypoints and press [ROUTE]. The
line between the two Waypoints is turned into a dotted line, see the following picture.
Move the ShuttlePoint knob to the desired location for the new Waypoint: the line will
"rubber-band", drawing a dotted line between the previous Waypoint and the cursor, and
another dotted line between the cursor and the next Waypoint (see the left side of the above
picture). Once you have positioned the cursor at the location you want, press [ENT] (see
the right side of the above picture).
Page 76
NOTE
Figure 9.5 - Inserting Waypoint procedure (1)
Figure 9.5a - Inserting Waypoint procedure (2)
CP190i and CPF190i