Table of Contents
Advertisement
1. After a location is found, peel the template label from the backing and apply the label
to the mounting area.
2. Drill a hole in one area of the cutout area that will allow the blade of a jig saw to be
inserted. Insert and cut out the area on the panel using the jig saw.
3. Next drill the four holes required to insert the GPS Chart Plotter with the mounting studs.
4. Install the mounting studs on the GPS Chart Plotter and insert into the mounting hole.
5. Attach the GPS Chart Plotter to the mounting location by attaching the supplied
hardware to the mounting studs.
M4 threaded
2.3
MOUNTING THE OPTIONAL EXTERNAL GPS ANTENNA
An external WAAS GPS antenna is available when the CPF180i or CPF300i is flush
mounted or mounted in an area where satellite reception is not possible with the internal
antenna. This antenna is designed to be mounted on a base, installed on an extension or
flush mounted.
Page 16
Figure 2.2a - Example of Flush installation on CPF300i
4 mm
20 mm
27 mm
Figure 2.2.0 - Mounting Screws
M4 threaded
CPF180i and CPF300i
Advertisement
Table of Contents
