Table of Contents
Advertisement
To set an Anchor Alarm, enter in a shallow water and deep water value above and below
your actual anchoring depth. The alarm will sound when the depth becomes shallower or
deeper than the settings.
17.14.0
Shallow Water
Triggers an alarm when depth becomes shallower than the set depth.
17.14.1
Deep Water
Triggers an alarm when depth becomes deeper than the set depth.
17.14.2
Fish
The Fish Alarm can be set to detect and alert you depending on the size of fish. The options
are: Off, Small, Medium, Big and Huge. The alarm sounds if the set size (or bigger) is
detected.
17.14.3
Temperature Upper
Triggers an alarm when the transducer reports a temperature above the set temperature.
17.14.4
Temperature Lower
Triggers an alarm when the transducer reports a temperature below the set temperature.
17.14.5
Temperature Rate
Triggers an alarm when the transducer reports a temperature variation rate above the set
temperature.
17.15 SAVE SETTINGS TO USER C-CARD
This option saves the complete set of Fish Finder settings to an optional User C-CARD. This
is useful to avoid the user having to retune up Fish Finder after a RAM Clear operation or
a software update.
CPF180i and CPF300i
Figure 17.14 - Alarms menu
Page 129
Advertisement
Table of Contents
