Table of Contents
Advertisement
13. ADVANCED SETTINGS
The Advanced Setup menu allows customization of many GPS functions, Alarms and
NMEA interfacing.
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press
[ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
While in this menu you will see many selections which are described in the next sections.
13.0
INPUT/OUTPUT (NMEA, AIS, RADAR)
13.0.0 Input
The CPF180i has 1 NMEA Input and 2 NMEA Outputs and the CPF300i has 3 Inputs and
3 Output connections.
These ports may be set up to receive and output the following.
· NMEA-0183 - NMEA devices* set to 4800 Baud (default setting)
· C-COM - C-Weather refer to Section 15
· Radar - SI-TEX optional Radar refer to Radar Owner's Manual
· AIS38400 - AIS Receiver, refer to Section 14
· MOBILARM - Mobil-arm receiver, refer to Section 16
· Disabled - allow the Port to be disabled.
When a Port is configured, both the Input and Output have the same setting.
Port1 is set to Radar, both the Input and Output wires are set to SI-TEX proprietary Radar
sentences. This means other devices should not be connected to the Input or Output wires.
RS232 not opto-isolated electrical interface
13.0.1 Ouput
The ports may be setup to output NMEA sentences. The table below shows the default
setting each port.
CPF180i
Sentence
GLL
VTG
BWC
WCV
APA
APB
HDG
Page 96
Port1
On
Off
Off
Off
Off
Off
Off
NOTE
NOTE*
Port2
On
Off
Off
Off
On
On
Off
CPF180i and CPF300i
Advertisement
Table of Contents
