Inserting A Waypoint Into A Route; Goto A Route; Using [Goto] To Select Route - Standard Horizon CPF390i Owner's Manual

5. To name the Route press [MENU]. Move the ShuttlePoint knob to highlight USER
POINTS and press [ENT].
6. Move the ShuttlePoint knob to highlight ROUTE and press [ENT].
7. Move the ShuttlePoint to highlight EDIT ROUTE and press [ENT] or move the
ShuttlePoint knob to the right.
8. Move the ShuttlePoint knob to highlight NAME and press [ENT] or move the Shuttle-
Point knob to the right. A popup window will be shown.
9. Move the ShuttlePoint knob up/down to change the characters and left/right to select
a different character in the Routes Name.
10. When finished press [ENT] to save.
11. Press [CLR] to show the Chart page is shown.
9.5

INSERTING A WAYPOINT INTO A ROUTE

Place the cursor on the navigation line between two Waypoints and press [I
between the two Waypoints is turned into a dotted line, see the following picture.
Move the ShuttlePoint knob to the desired location for the new Waypoint: the line will
"rubber-band", drawing a dotted line between the previous Waypoint and the cursor, and
another dotted line between the cursor and the next Waypoint (see the left side of the above
picture). Once you have positioned the cursor at the location you want, press [ENT] (see
the right side of the above picture).
9.6

GOTO A ROUTE

By having created some Routes, you can choose one of them to place a GOTO on.
9.6.0

Using [GOTO] to select Route

1. Move the ShuttlePoint knob to an open position (no buoy, warning etc. under the cursor)
on the Chart page.
2. Press [GOTO] to show the GOTO popup window.
3. Move the ShuttlePoint knob to highlight ROUTE and press [ENT].
Page 80
WAAS 3D
Figure 9.5 - Inserting Waypoint procedure (1)
WAAS 3D
Figure 9.5a - Inserting Waypoint procedure (2)
]. The line
NSERT
WAAS 3D
WAAS 3D
CP390i and CPF390i