Connecting The Gps Chart Plotters To The Ff520 - Standard Horizon Ff520 Owner's Manual

2.2

CONNECTING THE GPS CHART PLOTTERS TO THE FF520

CP155C/CP1000C/CP180/CP180i/CPV350 connections to FF520
1. If the power/data cable is plugged into the CP155C/CP1000C/CP180/CP180i/CPV350,
remove it.
2. Route the cable from the FF520 to the GPS Chart Plotters location.
NOTE
You can disconnect the "Tee" cable from the FF520 to make installation easier. Refer to Section 7.
3. Plug in the "Tee" connector into the GPS Chart Plotter DC/Data connector.
4. Plug in the power data cable into the "Tee" connector.
Figure 2.2 - CP155C Connection
Figure 2.2a - CP1000C Connection
CP180/CP180i
GPS antenna for
CP180i
Connector present
F 520 F
ONLY on
CP180
Tee Cable
Figure 2.2b - CP180/CP180i Connection
Page 10 FF520