Connecting The Gps Chartplotters To The Ff520 - Standard Horizon CP1000C Owner's Manual

2.2

CONNECTING THE GPS CHARTPLOTTERS TO THE FF520

CP155C and CP1000C connections to FF520
1. If the power/data cable is plugged into the CP155C or CP1000C, remove it.
2. Route the cable from the FF520 to the GPS Chart plotters location. Note the "Tee" cable
can be cut to run the cable, but care must be taken to ensure the cable is joined together
and sealed from moisture.
3. Plug in the "Tee" connector into the GPS Chart plotter DC/Data connector.
4. Plug in the power data cable into the "Tee" connector.
CP175C connections to FF520
1. Cut off the "Tee" connector on the FF520 as close to the "Tee connector as possible.
2. Route the cable from the FF520 to the CP175C location.
3. Step back the black insulation on the "Tee" cable about three inches to expose the wires
inside the cable. Connect the wires from the CP175C to the FF520 "Tee" cable referring
to figure 2.2b CP175C Connection.
Page 10
Figure 2.2 - CP155C Connection
Figure 2.2a - CP1000C Connection
Figure 2.2b - CP175C Connection
FF520