Zoom Operation; Selection Of An Objective (For The Triple Nosepiece) - Nikon Multizoom AZ100 Instruction Manual

Zoom Operation

The zoom knobs are located on the both sides of the zoom
body.
Rotation of these knobs allows the zoom magnification to be
changed in the range of 1x to 8x continuously.
Total magnification
The zoom magnification is indicated on the left zoom knob. The
microscope total magnification is determined with the following
formula:
Total magnification = zoom magnification
When the vertical tube is used, change the eyepiece
magnification to the vertical tube magnification (0.6x) to
calculate the total magnification.
The magnification of the AZ-ICI Coaxial Episcopic Illuminator
is 1.25x. Therefore, when the AZ-ICI is used, the total
magnification is obtained by multiplying the above formula by
1.25.
Zoom knob click ON/OFF
When the click ON/OFF lever on the bottom of the right zoom
knob is flicked to the "ON" side, the click-stop positions on the
zoom knob are provided at the integral multiples of the zoom
magnification (2x, 3x, 4x, 5x, 6x, and 7x).

Selection of an Objective (for the Triple Nosepiece)

When the AZ-NP3 Triple Nosepiece is used, it can be attached
with up to three objectives. To select an objective, rotate the
nosepiece to a click-stop position manually.
Chapter 3 Operation Procedures
x objective magnification
x eyepiece magnification
Zoom knob
Click ON/OFF
lever
Rotate the
part manually
11
Zoom operation
Triple nosepiece
Selection of an objective