• Tighten the lock nut 7.
NOTE:
Thread length b should be approx. 10 mm (0.39 in).
• Completely wipe off the fork oil from the spring and damper
rod assembly.
• Apply fork oil to the bushing 8.
• Insert the spring and damper rod assembly into the fork.
• Temporarily tighten the fork cap bolt 9 (sub-tank).
• Clamp the axle holder 0 with a vise. Protect the axle holder
0 with a rag when using a vise.
Clamping the axle holder 0 too tight can damage it
which will affect riding stability.
Do not clamp the axle holder 0 too tight.
• Compress the outer tube by hands and install the piston
holder (special tool) between the axle holder 0 bottom and
lock-nut 7.
09910-20115: Piston holder
b Approx. 10 mm (0.39 in)
WARNING
DISASSEMBLY AND ASSEMBLY 4-85