3 ] Uploading - Denso BHT-4000 User Manual

[ 3 ] Uploading

For uploading from the BHT-4000 to another BHT-4000, first select the
direct-connect interface port in System Mode (refer to [ 4.5 ] in this subsec-
tion) at each BHT-4000. Next, pull out the connector cover on each BHT-
4000 so that the direct-connect interface port will be exposed, and then use
the QM connector cable to connect them directly. (For details about the
interface cable, refer to Subsection 3.1.2.)
UPLOAD
1:Program File
2:Data File
⇓
UPLOAD PROGRAM FILE
EASYPACK.PD3
SAMPLE1.PD3
⇓
UPLOAD PROGRAM FILE
** Waiting **
⇓
Selecting "Upload " on the SYSTEM MENU
displays the screen shown at left.
1 Program File : Uploads a user pro-
2 Data File : Uploads a data file
Select a desired file by using the numerical
keys, then press ENT key. If more than
one file has been stored in the user area of
the RAM, use F5 and F7 keys to move
the cursor to the desired one and then press
ENT key.
In the center of the top line appears the
selected file--PROGRAM or DATA. The
screen shown at left selects PROGRAM file.
The BHT-4000 is waiting for a program file
(or a data file) to be uploaded.
For uploading from the BHT-4000 to
another BHT-4000, it is also neces-
sary to select a program file or data
file on the DOWNLOAD menu at the
receiving BHT-4000.
46
gram or Easy Pack 4.2
stored in the user area
of the RAM, to the host
computer.
stored in the user area
of the RAM, to the host
computer.