2 ] Downloading - Denso BHT-4000 User Manual

[ 2 ] Downloading

If you download a file having the same name as that already used in the user area
of the RAM in the BHT-4000, the newly downloaded file replaces the old one.
For downloading to the BHT-4000 from another BHT-4000 without routing the
CU-4000, first select the direct-connect interface port in System Mode (refer to
[ 4.5 ] in this subsection) at each BHT-4000. Next, pull out the connector cover
on each BHT-4000 so that the direct-connect interface port will be exposed, and
then use the QM connector cable to connect them directly. (For details about the
interface cable, refer to Subsection 3.1.2.)
DOWNLOAD
1:Program File
2:Data File
⇓
DOWNLOAD PROGRAM FILE
** Waiting **
⇓
Chapter 2. Getting Started the BHT-4000 and System Mode
Selecting "Download" on the SYSTEM
MENU displays the screen shown at left.
1 Program File : Downloads a user pro-
2 Data file
Select a desired file by using the numerical
keys, then press ENT key.
In the center of the top line appears the
selected file--PROGRAM or DATA. The
screen shown at left selects PROGRAM file.
The BHT-4000 is waiting for a program file
(or a data file) to be downloaded.
For downloading to the BHT-4000
from another BHT-4000, it is also nec-
essary to select a program file or data
file on the UPLOAD menu at the send-
ing BHT-4000.
The extension of program files to be
downloaded should be one of .PD3,
.EX3, and .FN3. (The .EX3 and .FN3
are reserved for future functional ex-
pansion.) The extension of data files
should be other than .PD3, .EX3, and
.FN3.
43
gram file or Easy Pack
4.2 (compiled by the
BHT-BASIC 3.0 Com-
piler), to the user area
of the RAM integrated
in the BHT-4000.
: Downloads a data file to
be used by a user pro-
gram, to the user area
of the RAM.