Numbered Options - GE Euro Simon Installation Instructions Manual

Note
A Keychain Touchpad button
can also be programmed to
control a light or appliance
module.
Note
Although the panel voice
prompts you through pro-
gramming, it is not neces-
sary to wait for the complete
message before pressing
the next button in the pro-
gramming sequence.
Euro Simon Security System
3. Press Unit # repeatedly until you hear the unit number that matches the one you chose for the
module.
4. Press Entry/Exit Delay. The panel confirms your programming.
¾
To add a sensor-activated module:
1. Press A .
DD
2. Press Light Control.
3. Press Unit # repeatedly until you hear the unit number that matches the one you chose for the
module.
4. Press Sensors until you hear the sensor you want to control the light.
5. Press DONE. The panel confirms your programming.
¾
To add a time-activated module:
1. Press Add.
2. Press Light Control.
3. Press Unit # until you hear the unit number that matches the one you chose on the module.
4. Press Time.
5. Press Hours and Minutes to set the beginning of the schedule.
6. Press DONE.
7. Press Hours and Minutes to set the end of the schedule.
8. Press DONE. The panel confirms your programming.
¾
To delete an Entry/Exit-activated module:
1. Press Delete.
2. Press Light Control.
3. Press Unit # repeatedly until you hear the unit number you want deleted.
4. Press Entry/Exit Delay, then press DONE. The panel confirms your programming.
¾
To delete a sensor-activated module:
1. Press Delete.
2. Press Light Control.
3. Press Unit # repeatedly until you hear the unit number you want deleted.
4. Press Sensors until you hear the one you want deleted.
5. Press DONE. The panel confirms your programming.
¾
To delete a time-activated module:
1. Press Delete.
2. Press Light Control.
3. Press Unit # repeatedly until you hear the unit number you want deleted.
4. Press DONE. The panel confirms your programming

Numbered Options

Numbered options let you customize system operation according to dealer and user needs.
The "Numbered Options" table in Appendix B lists all system options and their characteristics.
Fill in the last column of the table before programming to help speed up the programming pro-
cess.
There are two ways to reach the desired option setting.
• Press Add or Delete, then press Option # repeatedly until you hear the option you want
changed.
Or—
• Press Add or Delete, Option #, then enter the option number using the numbered keys.
The following instructions use the last method.
16