Table of Contents
Advertisement
Appendix A:
Troubleshooting
Euro Simon Security System
System Status
How to clear SYSTEM STATUS (Alarm Memory)
From a disarmed state press SYSTEM STATUS, listen to the status message, then press DIS-
ARM.
Panel announces Siren 1 failure or Siren 2 failure.
•
Turn option 53 off if a hardwire siren or sensor is not connected.
•
Check for the correct end-of-line resistor in HWIN 1 and 2 circuits.
Panel announces Low Battery.
•
Check that panel backup battery is connected.
Panel announces Option 50 Detected.
•
Option 50 is RF jam detect. The control panel has detected RF interference.
Panel announces that a sensor is open.
•
See Sensors section below.
Panel announces System time is not set.
•
Set the system time.
Control Panel
Panel announces Function not available when Chime Doors is pressed.
•
No sensors are programmed using sensor type 10 or 13.
Panel announces Function not available when Chime Special Motion is pressed.
•
No sensors are programmed using sensor type 25.
Panel announces Function not available when LIGHTS Time Activated is pressed.
•
No time activated lights have been programmed.
Panel announces Function not available when LIGHTS Sensor Activated is pressed.
•
No sensor activated lights have been programmed.
Panel announces Invalid. Sensor already programmed as Sensor Name.
•
This sensor is already programmed. Delete sensor if not correctly programmed.
Options (Programmable by the homeowner)
Panel does not beep.
•
Turn on (add) Option 1.
Latchkey does not function.
•
Latchkey time (option 3) is not set. Set Latchkey time.
•
Latchkey is not enabled. Enable Latchkey by pressing ARM Motion Sensors twice.
•
The phone number is not programmed properly. Reprogram the phone number. (options 13 or
43)
•
System Time is not set. Set system time.
Sensors
A sensor does not work.
•
Make sure the battery is fresh and installed correctly.
•
Check for interference from metal objects. Move or rotate the sensor.
•
Move the sensor to a new location.
Door or window is closed, but the panel announces it is open.
•
Be certain the arrow on the magnet and the guide line on the transmitter are aligned and
within 1/4 inch of each other.
•
The sensor tamper switch may be open (cover off).
42
Advertisement
Table of Contents
