Table of Contents
Advertisement
Note
Pressing DONE is required if
you enter fewer than 26 dig-
its. The phone number is
automatically stored without
pressing DONE if all 26
places are used.
27
Option 42: Speaker Level (Default = 8)
Sets the volume of voice messages from the panel speaker.
The volume can be set from 1 (lowest) to 8 (highest). Turning off this option returns the setting
to the default value.
¾
To set Speaker Level, press:
Add—Option #—42—1 - 8—DONE.
¾
To turn off Speaker Level (return to default), press:
Delete—Option #—42—DONE.
Option 43: Voice Event Notification Phone Number (Default = off)
Lets you program up to a 26-digit phone number for voice event notification (on), or delete an
existing phone number (off).
When programmed, a person at the remote phone location can hear system voice alarm
announcements. See the "Testing" section for more information.
Press Test for each required pause, Add for a *, and Delete for a # (each of which uses one of
the 26 available places).
¾
To set Voice Event Notification Phone Number, press:
Add—Option #—43—Up to 26 digits—DONE.
¾
To delete Voice Event Notification Phone Number, press:
Delete—Option #—43—DONE.
Option 44: Voice Event Notification Phone Mod 3 (Default = 09)
Determines the report content and reporting format when Option 43: Numeric Pager/Voice
Event Notification Phone Number is programmed. The following table describes the choices.
All entries must be 2 digits.
Setting #
08
Latchkey, No Activity, Phone Test, Openings, Closings,
Fail to Open/Close, AC Power Restorals/Failures
09
Same as setting 8 plus Alarms
10
Alarms only
¾
To set Voice Event Notification Phone Mod 3, press:
Add—Option #—44—10—DONE.
¾
To reset Voice Event Notification Phone Mod 3 (return to default), press:
Delete—Option #—44—DONE.
Option 45: Sensor Alarm Restoral Report (Default = off)
Determines whether the panel reports sensor alarm restorals (on), or not (off). The following
table describes the possible settings.
Setting
Off
1
2
3
Phone Mod 3
Content
Sensor Alarm Restoral Settings
When Restorals are Reported
No restoral reporting
Immediately after sensor is closed or
restored
After siren timeout expires
When system is disarmed
Format
Numeric Pager
Numeric Pager
Voice Event Notification
Euro Simon Security System
Advertisement
Table of Contents
