Table of Contents
Advertisement
Testing the
System
Note
An access code is required
when arming if Option 60:
Secure Arming is on.
Euro Simon Security System
Panic Code
The Panic Code is able to arm, disarm, or subdisarm the panel and send a silent alarm to the Cen-
tral Station. There will be no indication of an alarm at the panel.
¾
To add a code:
1. Press Add.
2. Press Access Code button. Continue pressing this button until you hear the access code to be
changed.
3. Press DONE.
4. Enter the new access code by using the numbered keys. The panel announces the new code.
¾
To delete a code:
1. Press Delete.
2. Press Access Code. Continue pressing this button until you hear the access code to be
deleted.
3. Press DONE. The panel announces the code is deleted.
This section describes how to perform the following test procedures:
•
Control Panel
•
Testing sensors
•
Testing phone communication
•
Testing central station communications
•
Testing the X-10 Lamp Modules
You should test the system after installing, after servicing, and after adding or removing devices
from the system.
Control Panel
Test the Control Panel by pressing the buttons as described below.
•
ARM Doors & Windows-The panel arms Doors & Windows. Press twice to eliminate the
programmed entry delay. The button will blink when No Entry Delay is on.
•
ARM Motion Sensors-The panel will arm Motion Sensors. Press twice to turn Latchkey on.
The button blinks when Latchkey is on.
•
DISARM -The panel will prompt you to enter an access code. Enter the appropriate code and
the panel will disarm Doors, Windows, and Motion Sensors.
Arming Level
0
Sub-disarms (Master Access and Panic codes only), and bypasses 24
hour intrusion sensors (Master Access Code only). Fire sensors (group
26) cannot be sub-disarmed.
1
Disarm the system
2
Arm Doors and Windows
3
Arm Motions
4
Arm Doors, Windows, and Motions
•Two beeps verify that Door/Window sensors are armed.
•One beep indicates the system is disarmed
•Three beeps verify that Motion Sensors are armed.
•Four beeps verify that both Door/Window and Motion sensors are armed.
•
SYSTEM STATUS-Press to determine system status and system time.
Arming Levels
Description of Level
36
Advertisement
Table of Contents
