Phone Numbers; Phone Options - GE Simon XT Installation Manual

Function Default
Downloader On
enable
Sup protest Off

Phone numbers

Table 12 below describes the Phone Numbers menu.
Table 12: Phone Numbers menu
Function Default
Phone #1 Blank
Phone #2 Blank
Phone #3 Blank
Phone #4 Blank
Downloader # Blank

Phone options

Table 13 below describes the Phone Options menu.
Table 13: Phone Options menu
Function Default
Man phone test On
FTC On
DTMF dial On
300 bps enabled On
Simon XT Installation Manual
Description
Enables programming of system options with downloader
software.
Determines whether the panel protests arming if it has not received
a supervisory signal from any sensor 15 minutes before arming
(on), or not (off). This feature must be turned on for US installations.
Description
Lets you program up to a 26-digit central monitoring station
receiver/voice event notification phone number for monitored
systems. Phone digits can be 0 to 9, *, #, or a pause (P).
To delete the phone number, press Disarm while editing a phone
digit. To add a pause to the phone number, press Bypass. Pressing
OK is required if you enter fewer than 26 digits.
Lets you program up to a 26-digit phone number for the Enterprise
Downloader.
Description
Determines whether you can perform a manual communication
test to verify communication to a central station/voice dial (on), or
not (off). If you have all four phone numbers programmed, it should
send a test report to all four before showing that the test is okay.
Determines whether the panel and interior sirens sound trouble
beeps if it is unable to successfully send a report to a central
station (on), or not (off).
Determines whether the panel uses DTMF (on) or pulse (off) for
dialing programmed phone numbers.
Determines whether the baud rate used by the panel for central
station communication is 300 bps (on), or 110 bps (off).
29