Smtp Setup Menu - Lexmark 280 User Manual

Menu item
Baud
1200
2400
4800
9600
19200
38400
57600
115200
138200
172800
230400
345600
Data Bits
7
8
Parity
Even
Odd
None
Ignore
Honor DSR
On
Off

SMTP Setup menu

Use the following menu to configure the SMTP server.
Menu item
Primary SMTP Gateway
Primary SMTP Gateway Port
Secondary SMTP Gateway
Secondary SMTP Gateway Port
SMTP Timeout
5–30
Reply Address
Description
Specifies the rate at which data can be received through the serial port
Notes:
9600 is the factory default setting.
•
138200, 172800, 230400, and 345600 baud rates are only displayed in the
•
Standard Serial menu. These settings do not appear in the Serial Option 1, Serial
Option 2, or Serial Option 3 menus.
Specifies the number of data bits that are sent in each transmission frame
Note: 8 is the factory default setting.
Sets the parity for serial input and output data frames
Note: None is the factory default setting.
Determines whether the printer uses the DSR Signal. DSR is a handshaking signal
used by most serial cables.
Notes:
Off is the factory default setting.
•
The serial port uses DSR to distinguish data sent by the computer from data
•
created by electrical noise in the serial cable. The electrical noise can cause stray
characters to print. Select On to prevent stray characters from printing.
Description
Specifies SMTP server port information
Note: 25 is the default SMTP gateway port. Range is 1-65536.
Specifies the amount of time in seconds before the server stops trying
to send the e-mail
Note: 30 seconds is the factory default setting.
Specifies a reply address of up to 128 characters in e-mail sent by the
printer
Understanding printer menus
116