Restarting The Kx-Ns500 - Panasonic KX-NS500 Installation Manual

7.1.5 Restarting the KX-NS500

If the PBX does not operate properly, restart the PBX using Web Maintenance Console. Before restarting the
PBX, try the system feature again to confirm whether there definitely is a problem or not.
Note
•
When the System Mode Switch is set to "NORMAL", restarting the PBX causes the following:
–
Camp-on is cleared.
–
Calls on hold are terminated.
–
Calls on exclusive hold are terminated.
–
Calls in progress are terminated.
–
Call park is cleared.
Other data stored in memory, except the above, are not cleared.
•
Be aware that restarting the PBX with the System Mode Switch in the "SYSTEM INITIALIZE" position
clears all data stored in the PBX. Do not perform this operation unless you intend to delete all data
from the PBX.
•
When the PBX is set to obtain IP addressing information automatically, and the PBX is not able to
obtain appropriate IP addressing information from an external DHCP server, the PBX starts up with its
default IP addresses and the STATUS indicator on the front of the cabinet turns red. For the default IP
addresses, refer to "5.3 Starting Web Maintenance Console".
Operation
If the PBX does not operate properly:
1.
Slide the System Mode Switch to the "NORMAL" position.
2.
Start the Web Maintenance Console.
3.
Log in using the Installer level account.
On the Home screen, click Maintenance ® System Control ® System Reset.
4.
5.
Follow the prompts.
Restarting the PBX will start.
Note
•
When the power switch is turned on, or when the PBX recovers from a power failure, the PBX will
restart. The time required to restart depends on the number of connected extensions.
System Mode Switch
7.1.5 Restarting the KX-NS500
Installation Manual 261