Panasonic KX-NS500 Installation Manual page 239

c.
Move the mouse pointer over the V-UTEXT32 card (Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
d.
Click Port Property.
e.
Click the Remote Place tab.
f.
Configure the items shown below.
•
Change the value Remote (MRG) to for Phone Location.
•
Change the value Enable for Web-MC Ability.
•
Select a protocol (HTTP/HTTPS) for Protocol for Remote SIP-MLT.
Note
Select the same value as you selected for NAT - SIP Proxy Server Port No. in step 5 of
"Programming the KX-NS500 with Built-in Media Relay Gateway" in this section.
g.
Click OK.
7.
Register the KX-UT series SIP phone. For details, refer to "5.8.1 Registering IP Telephones".
Note
•
You can select HTTPS for Protocol for Remote SIP-MLT only when Phone Location is set as
Remote (MRG).
•
If the KX-UT series SIP phone does not work normally, confirm whether the KX-UT series SIP
phone can access the internet.
5.8.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway
Installation Manual 239