System Log Server - D-Link xStack DES-3528 series User Manual

®
xStack DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual

System Log Server

The Switch can send Syslog messages to up to four designated servers using the System Log Server.
To configure the system log settings click Configuration > System Log Configuration > System Log Server
The following parameters can be set:
Parameter
Server ID
Server IP Address
UDP Port
(514 or 6000-65535)
Severity
Facility
Status
To add a new entry, enter the appropriate information and click Apply.
Figure 2 - 11 System Log Server window
Description
Syslog server settings index (1-4).
The IP address of the Syslog server.
Type the UDP port number used for sending Syslog messages. The default is 514.
This drop-down menu allows you to select the level of messages that will be sent. The options
are Warning, Informational, and All.
Some of the operating system daemons and processes have been assigned Facility values.
Processes and daemons that have not been explicitly assigned a Facility may use any of the
"local use" facilities or they may use the "user-level" Facility. Those Facilities that have been
designated are shown in the following: Bold font indicates the facility values that the Switch is
currently employing.
Numerical Facility Code
0 kernel messages
1 user-level messages
2 mail system
3 system daemons
4 security/authorization messages
5 messages generated internally by
syslog line printer subsystem
network news subsystem
7
UUCP subsystem
8
clock daemon
9
security/authorization messages
10
FTP daemon
11
Choose Enabled or Disabled to activate or deactivate.
Numerical
12
13
14
15
16
17
18
19
20
21
22
23
25
Facility Code
NTP subsystem
log audit
log alert
clock daemon
local use 0 (local0)
local use 1 (local1)
local use 2 (local2)
local use 3 (local3)
local use 4 (local4)
local use 5 (local5)
local use 6 (local6)
local use 7 (local7)