Connectivity Fault Management Settings - D-Link xStack DES-3528 series User Manual

®
xStack DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual

Connectivity Fault Management Settings

This window is used to configure the CFM settings on the Switch.
To view this window, click L2 Features > CFM > Connectivity Fault Management Settings as shown below:
The following parameters can be set or are displayed:
Parameter Description
CFM State
Used to Enable or Disable the CFM State.
MD
Enter the maintenance domain name you wish to create.
Level
Enter the maintenance domain level.
MD
Enter the maintenance domain name you wish to configure.
MIP
This setting controls the creation of MIPs.
None – Means that no MIPs will be created. This is the default value.
Auto – MIPs are created when the next lower active MD-level on the port is reached or there are
no lower active MD levels.
Explicit – MIPs are created when the next lower active MD-level on the port is reached.
SenderID TLV
Used to define the TLV data types of the maintenance domain. The user can choose between
None, Chassis, Manage or Chassis Manage.
To create a new entry enter the appropriate information and click Add. To configure the settings enter the appropriate
information and click Apply.
Figure 3 - 86 Connectivity Fault Management Settings window
Connectivity Fault Management Create(MD)
Connectivity Fault Management Settings(MD)
135