®
xStack
DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
CFM Loopback Settings
This window is used to configure the CFM Loopback settings on the Switch.
To view this window, click L2 Features > CFM > CFM Loopback Settings as shown below:
The following parameters can be configured:
Parameter
MEP Name (Max:32
characters)
MEP ID (1-8191)
MD (Max:22
characters)
MA (Max:22
characters)
MAC Address
LBMs Number (1-
65535)
LBM Payload
Length (0-1500)
LBM Payload
Pattern (Max:1500
characters)
LBMs Priority
Click Apply to implement changes made.
Figure 3 - 87 CFM Loopback Settings window
Description
The name of the Maintenance End Point.
The ID for the Maintenance End Point between 1 and 8191.
The Maintenance Domain Name.
The Maintenance Association Name.
The destination MAC address.
The number of LBMs to be sent the default value is 4.
The payload length of the LBM to be sent, the default value is 0.
The arbitary amount of data to be included in a Data TLV, along with the indication of whether
the Data TLV is to be included.
The 802.1p priority to be set in the transmitted LBMs. If not specified it uses the same priority
as CCMs and LTMs sent by the MEP.
136