®
xStack
DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
Parameter
Old Local Enable
Password
New Local Enable
Password
Confirm Local Enable
Password
RADIUS Accounting Services
The Accounting feature of the Switch uses a remote RADIUS server to collect information regarding events occurring
on the Switch. The following is a list of information that will be sent to the RADIUS server when an event triggers the
Switch to send these informational packets.
•
Account Session ID
•
Account Status Type
•
Account Terminate Cause
•
Account Authentic
•
Account Delay Time
•
Account Session Time
There are three types of Accounting that can be enabled on the Switch.
Network – When enabled, the Switch will send informational packets to a remote RADIUS server when network
events occur on the Switch.
Shell – When enabled, the Switch will send informational packets to a remote RADIUS server when a user either logs
in, logs out or times out on the Switch, using the console, Telnet, or SSH.
System - When enabled, the Switch will send informational packets to a remote RADIUS server when system events
occur on the Switch, such as a system reset or system boot.
Remember, this feature will not work properly unless a RADIUS Server has first been configured. This RADIUS server
will format, store and manage the information collected here.
To enable the RADIUS Accounting Settings on the switch, click Security > A ccess Authentication C ontrol >
RADIUS Accounting Settings
Description
If a password was previously configured for this entry, enter it here in order to change it to
a new password
Enter the new password that you wish to set on the Switch to authenticate users
attempting to access Administrator Level privileges on the Switch. The user may set a
password of up to 15 characters.
Confirm the new password entered above. Entering a different password here from the
one set in the New Local Enabled field will result in a fail message.
Figure 6 - 41 RADIUS Accounting Settings window
•
Username
•
Service Type
•
NAS IP Address
•
NAS Identifier
•
Calling Station ID
208