Attaching The Tripod; Power Supply; Using A Battery Pack - JVC GY-HM200U Instruction Manual

4k memory card camera recorder
Hide thumbs Also See for GY-HM200U:
Table of Contents

Advertisement

Attaching the Tripod

Use the screw hole at the bottom of this camera
recorder.
(3/8×16UNC, 1/4×20UNC)
Use the screw hole that suits the tripod.
To prevent the camera recorder from falling off,
which may result in injuries or damages, read the
instruction manual of the tripod to be used and
make sure that it is securely attached.
o Bottom
.
Caution :
Use the tripod on a stable surface.
0
To prevent the camera recorder from falling,
0
attach securely using the rotation prevention
hole.
Use screws with screw length 5 mm and below.
0

Power Supply

To use this camera recorder, you can attach a
battery pack or connect an AC adapter to it.
(A P29 [Using a Battery Pack] )
(A P31 [Using AC Power (DC IN Power)] )
Caution :
Set the [POWER ON/OFF] switch to "OFF"
0
before changing the power supply that operates
this camera recorder.

Using a Battery Pack

Charging the Battery
Charge the battery immediately after purchase or
when the battery power is running low.
* The battery is not charged when purchased.
2
4
1
.
1 Hold down the lock button (blue) at the
center of the [POWER ON/OFF] switch to set
to "OFF".
2 Attach the supplied battery.
Slide it in until you hear a click.
3 Connect the supplied AC adapter to the
[DC] terminal.
Open the cover of the [DC] terminal and connect
as shown in the diagram.
4 Connect the AC adapter to a power outlet.
The [POWER/CHARGE] lamp blinks during
0
charging and will go out after charging is
complete.
Remove the AC adapter after charging is
0
complete.
Memo :
Blinking of the [POWER/CHARGE] lamp during
0
charging indicates the charge level.
[POWER/CHARGE] Lamp
Alternates between a blinking
orange light (4 times) and
light off (1 second)
Alternates between a blinking
orange light (3 times) and
light off (1 second)
Alternates between a blinking
orange light (2 times) and
light off (1 second)
Alternates between a blinking
orange light (blinks once) and
light off (1 second)
Light goes out
You can charge the battery even when operating
0
the camera recorder using the AC adapter.
Settings and Adjustments Before Use
3
Charge Level
Less than 25 %
Less than 50 %
Less than 75 %
Less than 100 %
Fully charged
29

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gy-hm200eGy-hm170uGy-hm170e

Table of Contents