Table of Contents
Advertisement
Inserting an SD Card
This camera recorder comes with two card slots
(Slot A and B) for video/audio recording and
playback.
1
3
SD Card Cover
SD Card
.
1 Open the SD card cover by sliding the cover
in the direction indicated by the arrow.
2 Insert an SD card with the notched corner
pointing up.
The status indicator of the card slot to which the
card was inserted lights up in red.
3 Close the SD card cover in the direction
indicated by the arrow.
Card Slot Status Indicator
The following table shows the respective states of
slot A and B.
Lamp
Lights up in
The inserted SD card is being
red
accessed. (writing/reading data)
Do not turn off the power of the
camera recorder or remove the SD
card.
Lights up in
On standby. The inserted SD card
green
can be used for recording or
playback.
Light goes out
SD card is not inserted.
0
An unusable card is inserted.
0
An SD card is inserted but a
0
different slot is selected.
2
Slot Status
Removing the SD Card
1 Check that the SD card to be removed is not
being accessed (status indicator of the
card slot lights up in red).
2 Slide open the SD card cover.
3 Push the SD card and remove it from the
slot.
4 Close the SD card cover.
Memo :
When both slots are inserted with usable SD
0
cards, the previously selected slot is used.
Caution :
Data may be lost if you turn off the power of the
0
camera recorder or remove the SD card when it
is being accessed. All data recorded on the
card, including the file that is being accessed,
may be corrupted. Be sure to check whether the
status indicator is lit in green or turned off before
you turn off the power or remove the SD card.
If you mistakenly remove the card when it is
0
being accessed, reinsert the card only after the
status indicator goes off.
The SD card may not be recognized if you insert
0
and remove the card within a short time. When
this happens, remove the card and wait for a few
seconds before you reinsert.
41
SD Card
Advertisement
Table of Contents
